Arma-Blue

Arma-Blue
Manufactured in Australia

Arma-Blue is an advanced protection system based on a closed cell cross linked foam fused to a strong poly fabric – not harmful to the environment.

Arma-Blue Self Adhesive

A unique product specially developed to protect numerous types of membrane systems both in the horizontal and vertical plane. Both above and below ground applications.
Ease of installation and the knowledge that the sheet will not detach from the membrane surface under severe weather conditions that may follow eg; high winds etc. this gives peace of mind and assurance that your company can install Arma-Blue and leave the job without the fear of a call to say your protection install is all over town and not where it was meant to be.
NOTE: Application to cementitious or highly textured surfaces in the vertical plane will not bond successfully. It is recommended that a small trial patch be carried out on all surfaces to ensure proper adhesion. Extreme cold conditions may also affect bonding.

Further benefit using Arma-Blue is that once you have installed it over the membrane, you have less chance of your membrane being damaged by following trades or damage by UV exposure due to delays in construction or installation finishes as Arma-Blue is UV stable and will continue to protect surfaces for the life of the install.

Arma-Blue Self Adhesive

Other benefits are:

Fast install over other protection methods; less labour cost.
Performs as a slip sheet under toppings.
Has high abrasion resistance.
Will not decay or rot.
Will not expand or distort when exposed to heat or sunlight.
Minimum distortion under traffic use.
Good Impact Resistant.

Packaging

Arma-Blue Self Adhesive available in 25m x 1.2m wide roll size 30 sq.m. roll – Weight 12 kgs.

Installation Procedures to Install Arma-Blue Self Stick correctly

Ensure surfaces are dry.
Ensure surfaces are clean and dust free.
During application ensure all air is expelled between face of membrane and Arma-Blue sheet.
Allow to overlap Arma-Blue sheet by minimum of 20mm on each side lap.
Apply adequate pressure by and or broom to complete surface area of contact to ensure positive adhesion to substrate.
On vertical applications, should Arma-Blue be left exposed for extended periods it is recommended that Arma-Blue tape be applied at top edge of membrane to prevent possible leading edge peel.